Table of Contents
Advertisement
84
GETTING TO KNOW YOUR VEHICLE
Step Five
6. To release the wire harness, pull back on the red
latch (1), then push down on the black button (2)
while pulling the harness out.
Step Six
1 — Red Latch
2 — Black Button
7. Remove the hard top from the vehicle. Install the
provided edge protectors along the bottom edges of
the hard top, and place the hard top on a soft sur-
face to prevent damage.
CAUTION!
The removal of the Hard Top requires four adults
located on each corner. Failure to follow this caution
could damage the Hard Top.
8. Store the wire harness by removing the storage
cover on the quarter trim. Use the mechanical key
blade to pry the cover open.
Step Eight
9. Tuck the wire harness inside the storage compart-
ment, and replace the cover.
Step Nine
CAUTION!
•
The front panel(s) must be positioned properly to
ensure sealing. Improper installation can cause
water to leak into the vehicle's interior.
•
The hard top assembly must be positioned prop-
erly to ensure sealing. Improper installation can
cause water to leak into the vehicle's interior.
•
The hard top is not designed to carry any addi-
tional loads, such as after-market roof racks, spare
tires, building materials, hunting or camping sup-
plies, etc.
page 97.
•
Do not move your vehicle until the top has been
either fully attached to the windshield frame and
body, or fully removed.
•
The removal of the hard top requires four adults
located on each corner. Failure to follow this
caution could damage the hard top.
Advertisement
Table of Contents
