Adjusting Trimmer For User - Stihl FSA 30.0 Instruction Manual

English
2
1
1
► Position the blade (1) on the mowing head so
that the bushing (2) locates in the large bore in
the blade (1).
► Pull the blade (1) outwards until the bushing
(2) engages the small bore in the blade (1).
7.5.2 Removing the blades
► Switch off the brushcutter and remove the bat‐
tery.
30°
2
1
► Push the blade (1) inwards until the bushing
(2) is released from the small bore in the blade
(1).
► Remove the blade (1) upwards.
7.6 Attaching and removing the
mowing line
7.6.1 Fitting mowing lines
► Switch off the brushcutter and remove the bat‐
tery.
► Place mowing lines in a container filled with
water for 12 to 24 hours before using.
This makes the nylon mowing lines supple.
1
► Push the mowing line up through the right
opening from below.
14
2
2

8 Adjusting Trimmer for User

► Thread the mowing line through the left open‐
ing from above until the end of the line rea‐
ches the symbol.
► Hold the short end of the mowing line firmly.
► Pull the long end of the mowing line until it is
tight against the mowing head.
► Cut the mowing lines so that they extend as
far as the line limiting blade.
7.6.2 Removing the mowing lines
► Switch off the brushcutter and remove the bat‐
tery.
► Push the short end of the mowing line
upwards out of the mowing head.
► Pull the short end of the mowing line upwards
out of the mowing head.
► Pull the mowing line out of the mowing head.
8 Adjusting Trimmer for User
8.1 Adjusting the shaft angle
The shaft angle can be adjusted to suit the
height and reach of the user.
► Switch off the brushcutter and remove the bat‐
tery.
B
C
D
► Depress the lever (1) and hold it in that posi‐
tion.
► Move shaft (2) to the required position (A to D)
until it engages.
► Release the lever (1).
8.2 Adjusting the shaft length
The length of the shaft can be adjusted to suit
the height and reach of the user.
► Switch off the brushcutter and remove the bat‐
tery.
A
2
1
0458-039-0101-A