Table of Contents
Advertisement
English
8
Adjusting Trimmer for User
8.1
Fitting and Adjusting the Carry‐
ing System
1
2
► Put on the shoulder strap (1) or full harness
(3).
► Adjust the shoulder strap (1) or full harness (3)
so that the carabiner (2) is about a hand's
width below your right hip.
Other approved carrying systems are listed in
this User Manual,
8.2
Adjusting the bike handle
The bike handle can be set to different positions
to suit the height and reach of the user.
► Switch off the brushcutter and remove the bat‐
tery.
► Use the carrying ring to hook the brushcutter
into the carabiner of the carrying system.
a
► Loosen the wing screw (1).
► Tilt the bike handle (2) to the required position.
► Tilt the bike handle (2) so that the distance
does not fall below (a) = 750 mm.
► Tighten the wing screw (1) securely.
8.3
Balancing the brushcutter
The battery and cutting attachment affect the bal‐
ance of the brushcutter. The brushcutter must be
balanced with the attached cutting attachment
and the battery that is used.
16
3
2
21.1.
2
1
8 Adjusting Trimmer for User
The cutting attachment should rest lightly on the
ground.
► Switch off the brushcutter
► Connect the carrying ring (2) to the carabi‐
ner (1).
► Wait for brushcutter to stop swinging.
► Check the position of cutting attachment. If it
needs adjustment:
3
► Loosen the screw (3).
► Move the carrying ring (2) up or down the
shaft until a correct balanced position is
reached.
► Tighten the screw (3) securely.
2
1
2
0458-026-0101-A
Advertisement
Table of Contents
