Table of Contents
Advertisement
English
► Place the thrust plate (5) on the shaft (6) so
that its smaller diameter faces up.
► Place the metal cutting attachment (4) on the
thrust plate (5). If you are fitting a circular saw
blade or a grass cutting blade with more than
4 cutting edges: Its cutting edges must face in
the same direction as the arrow on the deflec‐
tor.
► Place the thrust washer (3) on the metal cut‐
ting attachment (4) so that its raised side faces
up.
► Place the rider plate (2) on the thrust washer
(3) so that its closed side faces up.
► Insert the stop pin (7) in the bore up to the limit
stop and hold it depressed.
► Rotate the metal cutting attachment (4) coun‐
terclockwise until the stop pin (7) engages in
position.
The shaft (6) is now blocked.
► Fit the nut (1) counterclockwise and tighten it
down firmly.
► Remove the stop pin (7).
8.6.2
Removing the metal cutting attach‐
ment
► Switch off the brushcutter and remove the bat‐
tery.
► Insert the stop pin in the bore up to the limit
stop and hold it depressed.
► Rotate the metal cutting attachment clockwise
until the stop pin engages in position.
The shaft is now blocked.
► Unscrew the mounting nut clockwise.
► Remove the rider plate, thrust washer, metal
cutting attachment and thrust plate.
► Remove the stop pin.
14
1
9.1
2
3
4
5
6
► Put on the shoulder strap (1) or full harness
► Adjust the shoulder strap (1) or full harness (3)
7
Other approved carrying systems are listed in
this User Manual,
9.2
The loop handle can be set to different positions
to suit the height and reach of the user.
► Switch off the brushcutter and remove the bat‐
► Undo the screws (2).
► Move the loop handle (1) to the required posi‐
► Tighten down the screws (2) so that the loop
9 Adjusting Trimmer for User
9
Adjusting Trimmer for User
Fitting and Adjusting the Carry‐
ing System
1
2
(3).
so that the carabiner (2) is about a hand's
width below your right hip.
22.
Adjusting and Setting the Loop
Handle
tery.
tion and check that the following conditions
are met:
– The bump guard (3) fits between the loop
handle (1) and carrying ring.
– If you are using a mowing head: a = no
more than 30 cm
– If you are using a metal cutting attachment:
a = no more than 25 cm
handle (1) cannot be rotated on the shaft.
3
2
1
a
2
3
0458-662-0121-C
Advertisement
Table of Contents
