Table of Contents
Advertisement
English
Check the following points
►
when mounting the charger on
a wall:
– Suitable fixing materials.
– The charger is level.
The following dimensions are observed:
– a = at least 100 mm
– b = 54 mm
– c = 4.5 mm
– d = 9 mm
– e = 2.5 mm
6.2
Charging the battery
The charging time depends on various factors,
e.g. the battery temperature or the ambient tem‐
perature. For optimum performance, observe the
recommended temperature ranges,
actual charging time may vary from the charging
time indicated. The charging time is indicated at
www.stihl.com/charging-times.
The charging process starts
automatically when the mains
plug is plugged into a socket
and the battery is inserted into
the charger. The charger
switches off automatically when
the battery is fully charged.
The battery and the charger warm up during
charging.
1
3
► Insert the mains plug (5) in a convenient wall
outlet (6).
The charger (2) runs a self test. The LED (3)
glows green for about 1 second and then red
for about 1 second.
► Fit the connecting cable (4).
► Insert the battery (1) in the guides in the
charger (2) and press it home as far as stop.
The LED (3) glows or flashes green. The bat‐
tery (2) is being charged.
12
20.6. The
2
5
6
4
► When the LED (3) stops glowing: The battery
(1) is fully charged and can be taken out of the
charger (2).
► If the charger (2) is no longer required. Dis‐
connect the mains plug (5) from the wall outlet
(6).
6.3
Displaying the State of Charge
1
► Insert the battery.
► Depress the pushbutton (1).
The LEDs light up steady green for about 5
seconds and indicate the state of charge.
► If the LED on the right flashes green: Charge
the battery.
6.4
LEDs on brushcutter
The LEDs can indicate the state of charge of the
battery or any faults. The LEDs can may light up
steady or flash in green or red.
If the LEDs light up steady or flash green, this
indicates the state of charge of the battery.
► If the LEDs light up steady or flash red: Trou‐
bleshooting,
19.1.
Malfunction in brushcutter or battery.
6.5
LED on Charger
The LED indicates the operating status of the
charger or faults. The LED can glow or flash
green or red.
If the LED glows or flashes green, the battery is
being charged.
► If the LED glows or flashes red: Troubleshoot‐
ing,
19.1.
There is a malfunction in charger or battery.
7
Assembling the Trimmer
7.1
Mounting the bump guard
► Switch off the brushcutter and remove the bat‐
tery.
7 Assembling the Trimmer
80-100%
60-80%
40-60%
20-40%
0-20%
0458-039-0101-A
Advertisement
Table of Contents
