Adjusting Trimmer For User - Stihl FSA 200.0 R Instruction Manual

9 Adjusting Trimmer for User

► Insert the stop pin (4) in the bore up to the limit
stop and hold it depressed.
► Turn the mowing head (1) counterclockwise
until the stop pin (4) engages in position.
The shaft (3) is now blocked.
► Tighten down the mowing head (1) firmly by
hand.
The mowing head is fastened tightly.
► Remove the stop pin (4).
8.5.2 Removing the Mowing Head
► Switch off the brushcutter and remove the bat‐
tery.
► Insert the stop pin in the bore up to the limit
stop and hold it depressed.
► Rotate the mowing head until the stop pin
engages in position.
The shaft is now blocked.
► Unscrew the mowing head clockwise.
► Remove the thrust plate.
► Remove the stop pin.
8.6 Removing and Installing Metal
Cutting Attachment
8.6.1 Mounting the Metal Cutting Attach‐
ment
► Switch off the brushcutter and remove the bat‐
tery.
► Place the thrust plate (5) on the shaft (6) so
that its smaller diameter faces up.
► Place the metal cutting attachment (4) on the
thrust plate (5). If you are fitting a circular saw
blade or a grass cutting blade with more than
4 cutting edges: Its cutting edges must face in
the same direction as the arrow on the deflec‐
tor.
0458-041-9601-A
► Place the thrust washer (3) on the metal cut‐
► Place the rider plate (2) on the thrust washer
► Insert the stop pin (7) in the bore up to the limit
► Rotate the metal cutting attachment (4) coun‐
► Fit the nut (1) counterclockwise and tighten it
► Remove the stop pin (7).
8.6.2
► Switch off the brushcutter and remove the bat‐
► Insert the stop pin in the bore up to the limit
► Rotate the metal cutting attachment clockwise
► Unscrew the mounting nut clockwise.
► Remove the rider plate, thrust washer, metal
► Remove the stop pin.
1
9.1
2
3
4
5
6
► Put on the shoulder strap (1) or full harness
► Adjust the shoulder strap (1) or full harness (3)
7
Other approved carrying systems are listed in
this User Manual,
9.2
The loop handle can be set to different positions
to suit the height and reach of the user.
ting attachment (4) so that its raised side faces
up.
(3) so that its closed side faces up.
stop and hold it depressed.
terclockwise until the stop pin (7) engages in
position.
The shaft (6) is now blocked.
down firmly.
Removing the metal cutting attach‐
ment
tery.
stop and hold it depressed.
until the stop pin engages in position.
The shaft is now blocked.
cutting attachment and thrust plate.
9 Adjusting Trimmer for User
Fitting and Adjusting the Carry‐
ing System
1
2
(3).
so that the carabiner (2) is about a hand's
width below your right hip.
22.
Adjusting and Setting the Loop
Handle
English
3
2
43