Epson WF-M4119 Series User Manual page 187

Administrator Information
Items
IPv6 Stateless Address 1
IPv6 Stateless Address 2
IPv6 Stateless Address 3
IPv6 Primary DNS Server
IPv6 Secondary DNS Server
IEEE802.11k/v
IEEE802.11r
Wi-Fi
You can check the Wi-Fi or Wi-Fi Direct connection status.
To display the Wi-Fi Direct status, click Wi-Fi Direct tab.
Note:
For models that support Wi-Fi, this item is displayed when the Wireless LAN Interface is installed.
❏ Setup button
When the Setup button is clicked, the Wi-Fi setup (infrastructure mode) screen is displayed.
❏ Disable Wi-Fi button
When the Disable Wi-Fi button is clicked, the Wi-Fi (infrastructure mode) function is disabled.
If you used to use Wi-Fi (wireless LAN) but no longer need to do so due to a change in connection mode and so
on, by removing unnecessary Wi-Fi signals, you can also reduce the load on the printer's standby power usage.
Note:
You can also set up from the printer's control panel.
Settings > General Settings > Network Settings
Configuring Wired LAN Settings
1. Enter the printer's IP address into a browser to access Web Config.
Enter the printer's IP address from a computer that is connected to the same network as the printer.
> >
Managing the Printer
Setting value and Description
Displays the valid IPv6 Stateless Address 1.
Displays the valid IPv6 Stateless Address 2.
Displays the valid IPv6 Stateless Address 3.
Enter the IPv6 primary DNS server in the following format.
❏ xxxx: xxxx: xxxx: xxxx: xxxx: xxxx: xxxx: xxxx
❏ xxxx is a hexadecimal number from 1 to 4 digits.
❏ If there are consecutive blocks where xxxx is all 0s, it can be omitted as ::.
(Only one place).
When assigning IPv6 Secondary DNS Server, enter in the following format.
❏ xxxx: xxxx: xxxx: xxxx: xxxx: xxxx: xxxx: xxxx
❏ xxxx is a hexadecimal number from 1 to 4 digits.
❏ If there are consecutive blocks where xxxx is all 0s, it can be omitted as ::.
(Only one place).
You can specify whether or not to enable IEEE802.11k/v.
Displayed only when the wireless LAN function is available.
You can specify whether or not to enable IEEE802.11r.
Displayed only when the wireless LAN function is available.
187
Managing the Network Connection