Epson WF-M4119 Series User Manual page 179

Administrator Information
❏ Unit
Select the unit of the user-defined size. You can select it when User defined is selected on Paper Size.
❏ Width
Set the horizontal length of the user-defined size.
The range you can enter here depends on the paper source, which is indicated on the side of Width.
When you select mm in Unit, you can enter up to one decimal place.
When you select inch in Unit, you can enter up to two decimal places.
❏ Height
Set the vertical length of the user-defined size.
The range you can enter here depends on the paper source, which is indicated on the side of Height.
When you select mm in Unit, you can enter up to one decimal place.
When you select inch in Unit, you can enter up to two decimal places.
❏ Paper Type
Select the paper type you want to set from the pull-down menu.
5. Check the settings, and then click OK.
Setting Errors
Set the displaying error for the device.
1. Enter the printer's IP address into a browser to access Web Config.
Enter the printer's IP address from a computer that is connected to the same network as the printer.
You can check the IP address of the printer from the following menu.
Settings > General Settings > Network Settings > Network Status > Wired LAN/Wi-Fi Status
2. Enter the administrator password to log in as an administrator.
3. Select in the following order.
Print tab > Error Settings
4. Set each item.
❏ Paper Size Notice
Set whether to display an error on the control panel when the paper size of the specified paper source is
different from the paper size of the print data.
❏ Paper Type Notice
Set whether to display an error on the control panel when the paper type of the specified paper source is
different from the paper type of the print data.
❏ Auto Error Solver
Set whether to automatically cancel the error if there is no operation on the control panel for 5 seconds
after displaying the error.
5. Check the settings, and then click OK.
>
Settings to Use the Printer
179
>
Using the Print Functions