Setting Up Airprint - Epson WF-M4119 Series User Manual

Administrator Information
Setting Universal Print
Set when you print from external devices without using the printer driver.
Some items are not displayed depending on the printing language of your printer.
1. Enter the printer's IP address into a browser to access Web Config.
Enter the printer's IP address from a computer that is connected to the same network as the printer.
You can check the IP address of the printer from the following menu.
Settings > General Settings > Network Settings > Network Status > Wired LAN/Wi-Fi Status
2. Enter the administrator password to log in as an administrator.
3. Select in the following order.
Print tab > Universal Print Settings
4. Set each item.
5. Check the settings, and then click OK.
Basic
Items
Top Offset(-30.0-30.0mm)
Left Offset(-30.0-30.0mm)
Top Offset in Back(-30.0-30.0mm)
Left Offset in Back(-30.0-30.0mm)
Check Paper Width
Skip Blank Page

Setting Up AirPrint

Set when using AirPrint printing.
Access Web Config and select the Network tab > AirPrint Setup.
Items
Bonjour Service Name
Bonjour Location
>
Settings to Use the Printer
Sets the vertical position of the paper on which printing starts.
Sets the horizontal position of the paper on which printing starts.
Sets the vertical position of the paper on which the printing of the back side of
the paper starts in duplex printing.
Sets the horizontal position of the paper on which the printing of the back side of
the paper starts in duplex printing.
Set whether to check paper width when printing.
If there is a blank page in the print data, set not to print a blank page.
Enter the Bonjour service name between 1 and 41 characters in ASCII (0x20-0x7E).
Enter location information such as the printer's placement within 127 bytes or less
in Unicode (UTF-8).
180
>
Setting Up AirPrint
Explanation
Explanation