Table of Contents
Advertisement
To connect indirectly to a device through a control processor via an AV LAN:
If your UCS 303 is connected to an AV LAN, you can connect to it through a control
processor such as an Extron IPCP, as follows:
1.
2.
3.
4.
5.
See the UCS 303 Help File, included with PCS, for instructions on using this software to
configure the UCS.
Updating Firmware
Extron periodically updates product firmware. Before updating any Extron product to the
latest revision level, be sure to read the supplied release notes or contact Extron Technical
Support to determine if your product requires a firmware update.
You can update firmware using PCS (see the UCS 303 Help File) the UCS 303 web page
(see
Firmware Loader
The Firmware Loader program enables you to upload new versions of firmware to your
UCS 303. The program also provides a means of uploading firmware files to multiple
devices simultaneously. When you are notified that new firmware is available for your
switcher, download the firmware file from the Extron website and install it on your computer
(see Downloading Firmware Loader). You can then upload the new version of firmware to
the switcher.
Before updating any Extron product to the latest revision level, be sure to read the supplied
release notes or contact Extron Technical Support to determine if your product requires a
firmware update.
Downloading Firmware Loader
ATTENTION:
In the IP Address/Hostname field of the
the previous page), enter the IP address of the UCS 303 on the AV LAN, as well as the
port number (the default is 4523) and the password.
Select the Enable Indirect Connection checkbox (
In the IP Address/Hostname field of the IP Link Control Processor with AV LAN
panel (
), enter the IP address of the control processor connected to the AV LAN.
4
Enter the password.
Click Connect (
). The TCP/IP window closes and the UCS device configuration
5
window opens.
Firmware panel
on page 60), or Toolbelt (see the Toolbelt Help File).
Valid firmware files must have the file extension .eff. A file with any other
•
extension is not a firmware upgrade for this product and could cause the device
to stop functioning.
Les fichiers firmware valides doivent contenir l'extension fichier .S19. Un fichier
•
avec n'importe quelle autre extension n'est pas une mise à jour de firmware pour
cet appareil et l'appareil pourrait arrêter de fonctionner.
Device panel (see figure 21,
Target
).
3
UCS 303 • Product Configuration Software
on
2
47
Advertisement
Table of Contents
