Table of Contents
Advertisement
TO MEMORIZE THE DATA (Min)
To memorize the setting of buttons or switches and the
transition of the levers and sticks, proceed as follows.
This figure blinks, and the
data is entered in this
column.
(E-FILE ze
oe
:
63 1 B11 ee
rE
er ee
TRANS!
!
TRURE
it
Por!
tt
psrioi
ot
a
Brot
1 Set the switches and buttons on the SEG-2550/2550P to the
condition to be memorized.
2 Place the event number in which the data is to be
memorized at the center by pressing the < key or the >
key.
3 Press the Min key.
The event number at the center on the screen starts
blinking, and the TAKE button also starts blinking.
4 Execute the effect to be memorized as follows :
Cut
Press the TAKE button, and the all data set on the panel is
automatically memorized at a time.
Transiti
1) Designate the lever or stick to be used by the
corresponding number, 0 through 9. The numbers of
sticks or levers are printed on the control panel.
To use the PGM/PST MIX lever: 0
To use the EFF lever: 1
Touse the INSERT lever: 3
Touse the POSITION stick: 4
To use the BACKGROUND COLOR stick: 5
To use the LUM control of BACKGROUND COLOR:
6
To use the COLOR MATT stick: 7
To use the LUM control of COLORMATT:
8
To use the SOFTNESS/BORDER controi: 9
2) Press the TAKE button.
Memorizing the movement of the designated lever or
stick starts
3) Move the stick or lever designated in step 1).
4) Press
the TAKE button again at the end of operation.
Memorizing the data is terminated. The period from
step 2 through 4) is also memorized in frame
numbers and displayed in "TRANS".
The data of an event is memorized. Repeat steps 1 through 4
to memorize the data more.
Notes on data entry
¢ When the transition memory is full, the indication of
TR-M will be FULL, and new data cannot be entered. To
enter the data, store the memorized data on a memory
device such as a floppydisk by a microcomputer, and
erase the data memorized in E-file.
© In the file in which the data has been memorized, the
data cannot be entered. To enter new data, erase the
memorized data, and enter the new data. For details on
erasing data, refer to "TO ERASE DATA".
° The event number can be automatically increased by one.
Refer to "MODE SETTING".
Advertisement
Table of Contents
