Toro Reelmaster 5510 Operator's Manual page 67

Note:
damaging the transmission.
4. Locate the brake release manifold near the front right tire and behind the hydraulic tank.
5. Insert a tube or similar object, hold the black
knob
manifold 3 times. As soon as there is
substantial resistance when pumping, the
brake is released.
Do not pump the manifold after it does not pump easily. Damage could occur if the
manifold is pumped too much.
Note:
approximately 60 minutes. If needed after 60 minutes, release the brake again by
pumping the manifold.
6. Push or tow the machine.
7. Set the brake by pulling the black knob out or starting the engine.
Note:
8. Close the bypass valves. Torque the valves to 11 N∙m (5 to 8 ft-lb).
Ensure that the bypass valves are closed before you start operating the machine.
Running the engine with an open bypass valve causes the transmission to overheat.
3464-490A
Because the fluid is bypassed, the machine can be moved slowly without
in on the manifold, and pump
Once the pressure is built up in the manifold, the brake will be released for
The brake automatically resets when you start the engine.
the
G439110
IMPORTANT
IMPORTANT
Page 5–27 Operation: Pushing or Towing the Machine