Toro Reelmaster 5510 Operator's Manual page 51

Overview of the InfoCenter Display (continued)
1. In Settings, scroll to Enter PIN and press the select button.
2. Enter PIN; refer to Accessing Protected Menus.
3. In Service, navigate to Hours and press the select button.
4. Scroll down to Service Due.
Note:
5. Highlight the service interval and press the select button.
Note:
Service interval is a protected menu item.
6. When the R
back button for N
7. After you select Y
selections.
Setting the Blade Count
1. In Machine Settings, scroll down to Blade Count.
2. Press the right navigation button to change the blade count between 8 or 11 blade reels.
Setting the Height of Cut (HOC)
1. In Machine Settings, scroll down to Height of Cut.
2. Use the left and right navigation buttons to select the HOC setting that matches the
bench setting of the cutting units. If the exact setting is not displayed, select the nearest
HOC setting from the list displayed.
Setting the Front and Rear Reel Speeds
Although the front and rear reel speeds are calculated by inputting the number of blades,
mow speed and HOC into the InfoCenter display, the setting can be manually changed to
accommodate for different mowing conditions.
1. To change the Reel Speed Settings, scroll down to the F R
both.
2. Press the right button to change the reel speed value. As you change the speed setting,
the display continues to show the calculated reel speed based on blade count, mow
speed and HOC, which was previously entered, but the new value is also displayed.
Setting the Maximum Allowed Mow Speed
The selected setting is displayed as an X on the traction-speed bar graph along with the
cruise control and pedal stop settings. An X in a bar denotes that the maximum speed is
limited by the supervisor.
Note:
This setting is retained in memory and applied to the traction speed until you change
it.
3464-490A
If service is currently due, Now appears next to Service Due.
The service interval (250 Hrs, 500 Hrs, etc) is located next to Service Due.
S T
ESET ERVICE IMER
.
O
, the interval screen clears and reverts back to the service hours
ES
? screen appears, press the select button for Y
Page 5–11
or the
ES
RPM, R R RPM, or
EEL EEL
Operation: Before Operation