Positioning the Turf Compensating Spring (continued)
2. Remove the 2 flange locknuts (3/8 inch)
and 2 carriage bolts (3/8 x 1-1/4 inches)
that secure the turf-compensator bracket
the cutting-unit frame.
3. Remove the flange locknut (3/8 inch)
secures the bolt
spring to the right tab
and remove the compensation spring from the
cutting unit.
Note:
from the bolt.
4. Assemble the bolt
spring to the right tab
with the flange locknut (3/8 inch)
5. Align the holes in the turf-compensator bracket
with the holes in the cutting-unit frame.
Note:
aligns toward the center of the machine
6. Assemble the turf-compensator bracket to the
cutting-unit frame with the 2 carriage bolts (3/8
x 1-1/4 inches)
inch)
7. Torque the locknuts and bolts to 37 to 45 N∙m
(27 to 33 ft-lb).
Setup: Installing the Cutting Units
of the turf compensation
of the carrier frame,
Do not remove the flange serrated nut
of the turf compensation
of the carrier frame
The support loop of the hose guide
and 2 flange locknuts (3/8
.
to
G410293
that
G410295
.
G410296
.
G411000
Page 3–7
3464-490 A