Table of Contents
Advertisement
The vehicle is on solid, non-slippery and level
R
ground.
The required tyre-change tool kit is available.
R
%
If your vehicle is not equipped with the tyre-
change tool kit, consult a qualified specialist
workshop to find out about suitable tools.
Apply the electric parking brake manually.
#
Move the front wheels to the straight-ahead
#
position.
Shift the transmission to position j.
#
Switch off the vehicle.
#
Make sure that the vehicle cannot be started.
#
Place chocks or other suitable items under the
#
front and rear of the wheel that is diagonally
opposite the wheel you wish to change.
Raising the vehicle when changing a wheel
Requirements
There are no persons in the vehicle.
R
The vehicle has been prepared for a wheel
R
change (
page 552).
/
Important notes on using the jack:
Use only a vehicle-specific jack that has been
R
approved by Mercedes-Benz to raise the vehi-
cle.
The jack is only designed for raising and hold-
R
ing the vehicle for a short time while a wheel
is being changed and not for maintenance
work under the vehicle.
The jack must be placed on a firm, flat and
R
non-slip surface. If necessary, use a large, flat,
load-bearing, non-slip underlay.
The foot of the jack must be positioned verti-
R
cally under the jack support point.
F243 0059 02
Wheels and tyres 553
Rules of conduct when the vehicle is raised:
Never place your hands or feet under the vehi-
R
cle.
Never lie under the vehicle.
R
Do not start the vehicle and do not release the
R
electric parking brake.
Do not open or close any doors or the tailgate.
R
Advertisement
Table of Contents
