Heating Elements - Vulcan-Hart VE30 Service Manual

ELECTRIC BRAISING PANS - REMOVAL AND REPLACEMENT OF PARTS
8. To install:
A. With drive key on drive shaft, install crank
assembly and tighten set screw against
key.
B. With drive key on manual crank shaft,
install shaft extension coupling and tighten
set screw against key.
C. Place gear reducer in its mounting location
on frame. Position gear reducer so the
shaft extension coupling is aligned with the
opening in control panel; and the lift arm is
vertical and parallel to the crank assembly
when connected.
NOTE: On the bottom lift arm bushing, the bushing
head must be positioned between the lift arm and
the crank assembly to create approximately 1/32"
spacing.
9. Reverse procedure from step 5 to complete the
installation.
10. Check for proper operation.
F35410 (May 2003)

HEATING ELEMENTS

1. Raise the pan to the full tilt position.
2. Remove harness cover.
3. Disconnect lead wires from the heating
element being replaced.
4.
Remove the insulation cover.
5. Remove heating element clamps (spring
loaded) from the clamp holder then remove
heating element.
Page 12 of 32
WARNING: DISCONNECT THE
ELECTRICAL POWER TO THE
MACHINE AND FOLLOW LOCKOUT /
TAGOUT PROCEDURES.