Vulcan-Hart E24L Service Manual page 33

3. Using a 5 ⁄ " socket wrench, remove (3) sheet metal screws securing the terminal block to the control
16
housing. Remove the block from the appliance. (Fig. 48)
4. Install new terminal block by reversing steps 1-3.
REPLACEMENT OF BREAKER
1. Lower kick panel.
5
2. With a ⁄ " socket, remove (2) hex head retaining screws holding the breaker cover over the breakers.
16
To remove the cover tilt the bottom right end over the exposed access panel screws. Slide the breaker
panel to the right until it touches the sidewall. Tilt the bottom left end out and over the left door spring and
pull the breaker cover panel out.
3. Note and remove breaker wiring using a large flat head screwdriver. (Fig. 49)
Fig. 48
Fig. 49
33