Vulcan-Hart E24L Service Manual page 13

REMOVAL OF ON-OFF AND 4-HEAT SWITCHS (EGO Hot top only)
1. Pull crumb tray out about 6".
2. Remove the screws at the top left and right corners of the control panel.
3. Lower panel on to the crumb tray.
4. Label and disconnect wires to the switch.
5. Lift panel up and pull off the switch knob.
6. Remove (2) switch mounting screws. (Fig. 10)
Fig. 10
7. Pull switch from the control panel.
8. Install new switch by reversing steps 1-7.
13