Configuration And Maintenance; Task 1; Load Application Code On A Blank Symbio 500; Task 2; Choose A Symbio 500 Configuration Option; Tack 3; Specify Controller Settings - Trane Symbio 500 Installation, Operation And Maintenance Manual

Configuration and Maintenance

The Tracer TU service tool is used to configure and maintain a Symbio 500 (refer to the following Tasks
1 through 9). Because the Symbio 500 is a self-serviceable unit, this device is not intended to be
disassembled by the user for maintenance. This manual assumes the user has basic knowledge of
using the Tracer TU service tool. Tracer TU operations, such as connecting to a controller directly using
a USB cable or connecting indirectly using Tracer SC+ pass-through and starting a Tracer TU session
are explained in the Tracer TU Getting Started Guide (TTU-SVN02). It is included on the Tracer TU
installation CD. In addition, you can refer to the Tracer TU Connection Online Help.

Task 1; Load Application Code on a Blank Symbio 500

All Symbio 500 controllers ship without application code.
1. Start the Tracer TU service tool to establish a connection with the Symbio 500. If no firmware is
2. Click OK. To load or upgrade the firmware, follow the procedure in the topic Upgrading Controller

Task 2; Choose a Symbio 500 Configuration Option

1. Become familiar with the parts of a Symbio 500 configuration. Refer to topic The Main Parts of
2. Read Point Configuration Overview in the Configuring and Managing Points of the Online Help for

Tack 3; Specify Controller Settings

Complete the following tasks:
•
•
•
For procedural information, refer to the topic, Modifying Controller Settings in the Online Help.
Task 4; Setup and Discover XM30, XM32, XM70, XM90 Expansion
Modules
1. Mount, wire, address, and power the expansion module as described in the Installation Instructions
2. Set up the module(s) using the controls on the Expansion Modules box on the Controller Settings
42
present, the following message displays, The Symbio 500 controller has no application code loaded.
Please launch File Transfer wizard and load an appropriate configuration.
Firmware under the Managing Configurations, Firmware, and Programs in the Online Help.
Device Setup and Configuration in the An Overview of Device Setup and Configuration of the Tracer
TU Online Help for Programmable Controllers.
an explanation of your configuration options. In addition, read the linked topics relevant to the
approach you want to take.
You have two main configuration options:
• Use the Tracer TU Configuration Screen to create a factory configuration.
Note: You can make some modifications to Trane factory blower coil, fan coil, or unit ventilator
configurations. Refer to the topic, An Overview of Editable Factory Configurations under
the Configuring and Commission Equipment > Trane Factory Blower Coils, Fan Coils,
and Unit Vents.
• Create or edit a custom (field programmed) configuration.
Configure units of measure.
Specify controller date and time.
Specify the baud rate, if other than the default (76800).
that accompany the unit. Refer to the topic, Setting Up And Discovering Expansion Modules under
the Modifying Controller Settings of the Online Help.
screen.
Note: If adding an expansion module on the Controller Settings page, but the module is not
connected to the controller, you will have to discover it on the Controller Status screen after it
is connected and powered.
BAS-SVX090B-EN