Getting Started; Setting Up Your Vtech Vt 2910C - VTech vt2910 User Manual

GETTING STARTED

Setting up your VTech VT 2910c

1. Choose an area near an electrical
outlet and telephone wall jack(s).
2. Plug the AC power adaptor into the
electrical outlet and the DC
connector to the back of the Base
Unit.
TEL.LINE
9V DC L1/L2 L2
AC
OUTLET
CAUTION: Use only the AC adaptor
shipped with your VT 2910c. This is a
Class 2 AC adaptor, specifically designed
for use with your telephone.
3. Set the TONE/PULSE switch, located
on the underside of the Base Unit.
Select the mode compatible with your
local telephone service (for most areas,
TONE is the preferred dialing mode).
4. Set the Base Unit RINGER switches
to ON or OFF, depending on your
preference.
5. C H A R G E T H E H A N D S E T
BATTERY PACK BEFORE USE.
The battery pack should be charged
for 16 hours before using your
phone for the first time.
VT2910C EN MANU
NOTE: Connect power to the Base Unit
before placing the Handset into the
cradle.
6. Connect the telephone line cords:
If you have 2 telephone lines
installed on a single jack (type RJ-
14), use the 2-line cord provided. This
TELEPHONE
WALL JACK
is a 4 wire cord with a black tip at each
end. Plug one end of this cord into the
jack marked L1 or L1/L2 , located on
the back edge of the Base Unit. Plug
the other end of this cord into your 2-
line wall jack.
If you have 2 separate telephone
line jacks (2 RJ-11 jacks), plug one
telephone line cord into the jack
marked L1 or L1/L2 , and another cord
into the jack marked L2 . In this
situation, it does not matter which line
cord you choose for each line. Plug
the other end of the 2 line cords into
your separate wall jacks.
NOTE: For two line operation, you must
have 2 telephone lines, each with their
own unique phone number. If you have
only one telephone line, your VT 2910c
will still operate, but only as a single line
phone.
7. CHECK FOR DIAL TONE. After the
battery pack is charged, raise the
Base Unit Antenna to an upright
position. Then, pick up the Handset
and press LINE 1 or LINE 2. The
LCD should display HANDSET ON
1 (or 2 ), and you should hear a dial
tone. If you do not hear a dial tone,
there may be a problem with the
telephone jack or the wiring. See IN
CASE OF DIFFICULTY.
20
20 12/16/99, 6:17 AM