Table of Contents
Advertisement
BASE UNIT FEATURES
CONFERENCE (CONF) KEY
Press this key to conference LINE 1 and
LINE 2.
HOLD KEY
Press this key to place your call on
HOLD.
Press the appropriate LINE key to
cancel HOLD.
In CONFERENCE mode, press this key
to place both lines on HOLD. Press
CONF to cancel HOLD.
MUTE KEY
Press this key to disable the Base Unit
microphone during a call (or during
INT.COM mode). Press this key again
to cancel MUTE.
INTERCOM KEY
Press this key to page the Handset. If the
Handset user responds by pressing
INTERCOM, the INTERCOM LED on the
Base Unit will glow and the 2 parties can
now talk. The Handset user can also
choose to terminate the page by pressing
OFF.
Press OFF to exit from the INTERCOM
mode.
This feature can be used as a Handset
locator. The Handset will ring a
maximum of 5 times, giving you an
opportunity to find it.
VOLUME UP & DOWN KEYS
Press these keys to raise and lower the
Speakerphone volume level. You can
hold a key down to achieve maximum
(or minimum) volume.
VT2910C EN MANU
RINGER ON/OFF SWITCHES
Located on the right edge of the Base
Unit (antenna side), these switches
control the Base Unit ringer for each line.
These switches have no effect on the
Handset ringers.
TONE/PULSE SWITCH
Located on the underside of the Base
Unit, set this switch to the dialing mode
compatible with your local telephone
service. For most areas, TONE is the
preferred dialing mode.
19
19
12/16/99, 6:17 AM
Advertisement
Table of Contents
