In Case Of Difficulty - VTech vt2910 User Manual

IN CASE OF DIFFICULTY

If you have difficulty operating your
phone, the suggestions below should
solve the problem. If you still have
difficulty after trying these suggestions,
In the US call:
VTech Communications at
1-800-595-9511
In Canada call VTECH Electronics at
1-500-267-7377
THE PHONE DOESN'T WORK AT
ALL.
• Make sure the power cord is plugged
in.
• Make sure the telephone line cord is
plugged firmly into the Base Unit and
the telephone wall jack.
• Make sure the battery pack is prop-
erly charged. If the LOW BATTERY
is displayed on the Handset, the
battery pack needs charging. If the
IN USE LED (on the Base Unit) and
the PHONE LED (on the Handset)
do not light when you press
PHONE, you should charge the
battery pack.
• If you recently installed a new battery
pack, make sure it is installed
correctly.
NO DIAL TONE.
• First check all the suggestions above.
• If you still don't hear a dial tone,
disconnect the Base Unit from the
telephone jack and connect a
different phone. If there is no dial
tone on that phone either, the
problem is in your wiring or local
service. Call your local telephone
company.
VT2910C EN MANU
YOU GET NOISE, STATIC, OR A
WEAK SIGNAL EVEN WHEN YOU'RE
NEAR THE BASE UNIT.
• Place the Handset in the Base mo-
mentarily to re-set the security code.
Then press PHONE to get a line.
Household appliances plugged into the
same circuit as the Base Unit can
sometimes cause interference. Try
moving the appliance or the Base Unit
to another outlet.
YOU GET NOISE, STATIC, OR A
WEAK SIGNAL WHEN YOU'RE
AWAY FROM THE BASE UNIT.
• You may be out of range. Either
move close to the base, or relocate
the Base Unit.
• The layout of your home may be
limiting the range. Try moving the
Base Unit to the second or third floor,
or to some other location.
THE HANDSET DOES NOT RING
WHEN YOU RECEIVE A CALL.
• Ensure that the ringer is turned on.
• Make sure the telephone line cord is
plugged firmly into the Base Unit and
the telephone jack. Make sure the
power cord is plugged in.
• You may be too far from the Base
Unit.
• You may have too many extension
phones on your telephone line to
allow all of them to ring. Try
unplugging some of the other
phones.
THE BASE DOES NOT RING
• Make sure the BASE RINGER
switch is not set to off.
• There may be too many extension
phones on your line. Try unplugging
32
32 12/16/99, 6:18 AM