Table of Contents
Advertisement
WALL MOUNTING
The Wall Mount adaptor is designed
to fit on standard Wall Mount plates.
1. Choose a spot near an electrical
outlet and a telephone jack. Your
phone requires a modular telephone
jack and a standard electrical outlet
(120v AC). The power cord is six
feet long; make sure there is an elec-
trical outlet within reach of the base.
The outlet should not be controlled
by a wall switch. If the switch is ever
turned off, the phone will not oper-
ate.
2. Position the wall mount adaptor
on the base. Line up the tabs on
the wall mount adaptor with the holes
on the bottom of the base. Snap the
wall mount adaptor firmly in place.
3. Mount the Base on the wall. Posi-
tion the Base so the mounting studs
will fit into the holes on the bottom of
the Base. Position the power cord
to extend down the wall the phone
is to be mounted on. Slide the base
down on the mounting studs until it
locks into place.
4. Connect the telephone cord. The
telephone line cord has a snap-in
plug at each end. Insert one of the
plugs into the jack on the bottom of
the Base. Insert the other end of the
plug into the wall jack.
5. Plug the AC adaptor on the power
cord into an electrical outlet.
VT2910C EN MANU
MEMORY DIALING
1
11
2
12
3
13
4
14
5
15
6
16
7
17
8
18
9
19
10
20
9
9
POWER
CHARGING
SPARE BATT
DIGITAL
900MHz
CORDLESS
VOLUME
VT 2910c
INT.COM
HOLD
MUTE
CONF
.
LINE 1
LINE 2
OFF
12/16/99, 6:16 AM
Advertisement
Table of Contents
