Table of Contents
Advertisement
Standby
•
Turns on the appliance to the last used
settings without any heat.
•
Places the appliance into standby mode
with all features turned off.
Plus (+) and minus (-) buttons
Use to navigate the different on-screen menus.
Flame speed
Press once to enter the flame speed menu,
SPd will show on the screen. Press the + or -
buttons to adjust the flame speed. The flame
speed is indicated on the screen by bars, one
bar is the slowest setting, five bars the highest.
Flame colour
Repeatedly press to cycle through the flame
colour menu. While in the flame colour menu,
press the + or - buttons to increase or decrease
the flame brightness, one bar is the lowest
setting, five bars is the brightest setting.
FL.0
Flame off
FL.1
Red
FL.2
Orange
FL.3
Yellow
FL.4
Green
Fuel bed colour
Repeatedly press to cycle through the fuel
bed colour menu. While in the fuel bed colour
menu, press the + or - buttons to increase or
decrease the fuel bed brightness, one bar is the
lowest setting, five bars is the brightest setting.
Fb.0
Flame off
Fb.1
Red
Fb.2
Orange
Fb.3
Yellow
Fb.4
Green
Timer mode
Repeatedly press to cycle through timer
options. Select an amount of time for the
appliance to operate, then to automatically turn
off. Choose between 0.5, 1, 2, 3, 4, 5, 6, 7, 8, 9
hours.
Eco
This mode will reduce the brightness of all
lighting modes and limit the heat output to a low
setting. To exit this mode, press the button a
second time.
FL.5
Light blue
FL.6
Dark blue
FL.7
Violet
FL.8
White
FL.9
Multi-colour change
Fb.5
Light blue
Fb.6
Dark blue
Fb.7
Violet
Fb.8
White
Fb.9
Multi-colour change
Fuel bed downlight
Repeatedly press to cycle through the fuel bed
downlight colour menu. While in the fuel bed
downlight menu, press the + or - buttons to
increase or decrease the fuel bed brightness,
one bar is the lowest setting, five bars is the
brightest setting.
dL.0
Light off
dL.1
Red
dL.2
Orange
dL.3
Yellow
dL.4
Green
Heater
Press to cycle through the heating options:
•
1 press: CO.A
•
2 presses: H.Lo
•
3 presses: H.HI
•
4 presses: no.H
While in heater mode, after selecting the low
or high heat setting, press the - and + buttons
to select the temperature you want the room to
reach.
If the room temperature is already higher
than the temperature selected, the unit
NOTE
will not activate.
To switch between °C or °F, hold the - and +
buttons for three seconds.
Open window detection is an innovative eco
feature that detects a rapid drop in room
temperature caused by an open window. The
warning word 'OPn' will be displayed on the
screen and the unit will be turned off. If the
room temperature rises, or the remote control
is operated manually, the unit will return to its
normal working state.
Sound effect
Press the sound effect button:
•
1 press: S.on
•
2 press: no.S
While in the sound effect menus, press the -
and + buttons to increase and decrease the
volume, one bar is the quietest setting.
Electric fires operation and installation guide 17904-B | 7
dL.5
Light blue
dL.6
Dark blue
dL.7
Violet
dL.8
White
dL.9
Multi-colour change
= cool blow
= low heat
= high heat
= no heat
= Sound effect on
= Sound effect off
Advertisement
Table of Contents
