Table of Contents
Advertisement
r [Control System]
Configure the setting for the control system required to connect to the projector as a client.
1
[Use TLS]
Sets the secure communication.
[Disable]:
Performs the unsecured communication.
[Enable]:
Performs the secure communication using TLS (Transport
Layer Security).
2
[IP Address / Hostname]
Enter the IP address or the host name of the connection
destination.
3
[IP ID]
Sets the IP ID used to determine the projector on the network.
(A number up to four digits)
Default value: 3
4
[Room ID]
Sets the Room ID used to determine the projector on the
network. (Up to 32 half-width characters)
5
[Non Secure Port]
Sets the port number to be used with the unsecured
communication.
Default value: 41794
Note
f When [Use TLS] is set to [Disable], [Authentication] is fixed to [Disable], and [Secure Port] cannot be set.
Chapter 5 Operations — Using the web control function
1
2
3
4
5
6
7
8
9
10
6
[Secure Port]
Sets the port number to be used with the secure
communication.
Default value: 41796
7
[Authentication]
Select the authentication with the connection destination used
with the secure communication.
[Disable]:
Does not perform the connection authentication.
[Enable]:
Performs the connection authentication.
8
[User Name]
Enter the user name used for the connection authentication.
(Up to 20 half-width characters)
9
[Password]
Enter the password used for the connection authentication. (Up
to 20 half-width characters)
10 [Submit]
Updates the [Control System] setting.
ENGLISH - 245
Advertisement
Table of Contents
