Table of Contents
Advertisement
f Proceed to Step 9) when [OFF] is selected.
f Proceed to Step 11) when [PC] is selected.
7)
Press as to select [LINK].
8)
Press qw to switch the item.
f The items will switch each time you press the button.
[OFF]
[GROUP A]
[GROUP B]
[GROUP C]
[GROUP D]
f Proceed to Step 11) when [AUTO] is selected in Step 6).
9)
Press as to select [STARTUP CALIBRATION].
10) Press qw to switch the item.
f The items will switch each time you press the button.
[OFF]
[ON]
11) Press as to select [REGULAR CALIBRATION].
12) Press qw to switch the item.
f The items will switch each time you press the button.
[OFF]
[ON]
f Proceed to Step 17) when [OFF] is selected.
13) Press as to select [CALIBRATION TIME].
14) Press the <ENTER> button.
f The projector is in the adjustment mode (the time is blinking).
15) Press qw to select "hour" or "minute", and press as or the number (<0> - <9>) buttons to set a
time.
f Selecting "hour" allows setting of only the hour in increments of one hour, and selecting "minute" allows
setting of only the minute in increments of one minute between 00 and 59.
16) Press the <ENTER> button.
f [CALIBRATION TIME] is set.
17) Press as to select [CALIBRATION MESSAGE].
18) Press qw to switch the item.
f The items will switch each time you press the button.
[ON]
[OFF]
19) Press as to select [APPLY].
20) Press the <ENTER> button.
f When [CONSTANT MODE] is set to anything other than [OFF] and the <ENTER> button is pressed in
following cases, the brightness and color of the light source at that time is set as the correction target for the
brightness and white balance of the screen, and the automatic correction will start.
164 - ENGLISH
Chapter 4 Settings — [PROJECTOR SETUP] menu
Performs automatic correction by this projector alone without synchronizing with other projectors.
The duration that the constant brightness is kept will become longer by setting the value of [LIGHT
OUTPUT] smaller.
Performs automatic correction by synchronizing multiple projectors.
Up to four groups (A to D) can be set within the same subnet by using the network function.
You can register and synchronize up to eight projectors in one group.
Does not measure the brightness and color of the light source when the power is turned on.
Measures the brightness and color of the light source by the brightness sensor after the power is
turned on and the light source is illuminated.
Does not measure the brightness and color of the light source periodically.
Measures the brightness and color of the light source by the brightness sensor at the time specified
by [CALIBRATION TIME].
Displays the time to complete the measurement while the brightness and color of the light source are
measured by the brightness sensor.
Does not display a message during the measurement.
Advertisement
Table of Contents
