Table of Contents
Advertisement
f The projector goes into the standby mode once the update is started, and the light source indicator
<LIGHT1> and the light source indicator <LIGHT2> blink red alternately.
10) Confirm the firmware version.
f Update is completed when the light source indicators <LIGHT1> / <LIGHT2> stop blinking and turn off.
f Turn on the power of the projector and confirm the firmware version in the [STATUS] screen.
Attention
f Do not disconnect the main power supply of the projector while updating.
Note
f If the update does not complete after 60 minutes or more have elapsed, turn the power of the projector off and on and perform the update
from the beginning.
f If the power of the projector is turned off by a power outage or other reason during the update, the update is automatically restarted after the
power outage is restored or right after the power of the projector is turned on again.
Update in standby mode
Rewriting of the firmware can be performed by operating the buttons on the control panel even if the projector is in
the standby mode.
Set the [PROJECTOR SETUP] menu → [STANDBY MODE] to [NORMAL] in advance. If [ECO] is set, the
firmware cannot be updated in standby mode.
1)
Insert the USB memory with the firmware data saved into the <USB> terminal of the projector.
2)
Confirm that the projector is in the standby mode.
3)
Press in order of aass on the control panel, and press the <ENTER> button.
f The projector will go into the update ready state.
f Once the projector goes into the update ready state, the power indicator <ON (G)/STANDBY (R)> will turn
off, and the light source indicator <LIGHT1> and the light source indicator <LIGHT2> will light up red.
4)
Enter a security password and press the <ENTER> button.
f Update is started.
f Once the update is started, the power indicator <ON (G)/STANDBY (R)> will light up red, and the light
source indicator <LIGHT1> and the light source indicator <LIGHT2> will blink red alternately.
f Update is completed when the light source indicators <LIGHT1> / <LIGHT2> stop blinking and turn off.
Attention
f Do not disconnect the main power supply of the projector while updating.
Note
f The security password is the password set in the [SECURITY] menu → [SECURITY PASSWORD CHANGE].
Initial password of the factory default setting: awsqawsq
f If the update does not complete after 60 minutes or more have elapsed, turn the power of the projector off and on and perform the update
from the beginning.
f If the power of the projector is turned off by a power outage or other reason during the update, the update is automatically restarted after the
power outage is restored or right after the power of the projector is turned on again.
f If the security password is not entered for approximately 60 seconds in the update ready state, the update ready state will be canceled and
the projector will go into standby mode.
266 - ENGLISH
Chapter 5 Operations — Updating the firmware
Advertisement
Table of Contents
