Removing The Ribbon Shield; Installing The Ribbon Shield - IBM 5225 1 Operator's Manual

Installing the Ribbon Shield
4-4 GA34-0054
Note: The printer can not operate with the top cover open. This is for your
safety. If the printer has the audible alarm (optional), press the Stop Reset
key to switch off the alarm.
2. Release the forms feed by pushing down on the release latches.
3. Remove the ribbon shield
G
from the.tension fingers assembly
O·
1. Open
the
printer top cover and the forms feed assembly.
2. Locate the tension fingers assembly.
3. Be sure the base
9
of the tension fingers assembly is clean.
4. Remove the paper strip from the adhesive backing
8
on the shield.
5. Attach the ribbon shield to the front of the tension fingers assembly. The left
edge
O
and botton edges
8
of the shield should touch the angled edges of
the tension fingers assembly as shown.
6. Press firmly on the adhesive area
8
to secure the shield to the tension fingers
assembly.
(
\