Installing And Aligning The Appliance - Thermador T18 Series Installation Instructions Manual

12. Installing and aligning the appliance
CAUTION
Never use a cordiess screwdriver!
Risk of damage to the appliance.
— Do not twist or jam the appliance inside the cavity!
When unscrewing the neight-adjustable feet,
proceed gradually: Always alternate between left
and right, left and right, etc..
— The adjustment of the rear feet is facilitated if the
appliance is unloaded at the rear.
— Do not bend the appliance against the anti-tip-
angies.
m= Align the appliance with the furniture fronts.
Place marking-out level over the installation aid parts on
the door.
26
The installation aid parts on tne door nave been designed for
the following total thickness of furniture doors:
— 3/4" (49 mm)
= 11/5" (88 mm)
Always take account of the possible differing thickness of the
furniture fronts which are to be fitted sulbbsequently.
The height-adjustabie feet at the front and rear can all be
adjusted from the front.
Front:with open-ended wrench 1/5" (SW13)
Rear:with 5/46" (8 mm) hex nut driver via flexible shaft.
A mark is attached to the appliance base and is used as
a standard gage for height adjustment. When adjusting the
height, align this mark at a height of 11/5" (82 mm) above
the floor.
m= Unscrew the height-acdiustabie feet until the mark on
the base has reached the indicated guide dimension
(11/4°/32 mm).
It is very important to comply with this dimension for
the subsequent alignment of the furniture fronts.
m= Align the furniture fronts with the spirit level.