Product Specific Applications; Worker Classifications; Applicable Safety Standards - Guardian CR3 SELF-RETRACTING LIFELINE Instruction Manual

Product Specific Applications

May be used to support a MAXIMUM 1 in
a Personal Fall Arrest System (PFAS)
for use in Fall Arrest applications.
Structure must withstand loads applied in the
directions permitted by the system of at least
5,000 lb (22.2 kN) No free fall is permitted.
D-ring: Dorsal
May be used in Travel Restraint
applications. Restraint systems prevent a
worker from reaching the leading edge of
a fall hazard. Always account for fully extended
length of connecting equipment. Structure must
withstand loads applied in the directions permitted
by the system of at least 1,000 lb (4.4 kN) No free
fall is permitted. Restraint systems may only be
used on surfaces with slopes up to 4/12 (vertical/
horizontal).
D-rings: Dorsal

Applicable Safety Standards

Meets or exceeds:
ANSI/ASSP Z359.14-2021

OSHA 1910.140

OSHA 1926.502

For All Product Applications
Maximum user weight (including all

clothing, tools, and equipment) is:
ANSI: 130 - 310 lb (59 - 141 kg)
OSHA: 100 - 420 lb (45 - 191 kg)

Worker Classifications

Qualified Person: A person with an

accredited degree or certification, and
with extensive experience or sufficient
professional standing, who is considered
proficient in planning/reviewing the
conformity of fall protection and rescue
systems.
Competent Person: A highly trained and

experienced person who is ASSIGNED
BY THE EMPLOYER to be responsible
for all elements of a fall safety program,
including, but not limited to, its regulation,
management, and application. A person
who is proficient in identifying existing and
predictable fall hazards, and who has the
authority to stop work in order to eliminate
hazards.
Authorized Person: A person who is

assigned by their employer to work around or
be subject to potential existing fall hazards.
Compatibility
When making connections to the SRL, eliminate
all possibility of roll-out. Roll-out occurs when
interference between a connector and the
attachment point causes the connector gate to
unintentionally open and release.
All connections must be selected and deemed
compatible with the SRL by a Competent Person.
All connector gates must be self-closing, self-
locking, and withstand a minimum load of
3,600 lb (16 kN).
See Diagram A on page 7.
2