Engine Oil - APRILIA LEONARDO 250 Workshop Manual

Hide thumbs Also See for LEONARDO 250:
Table of Contents

Advertisement

PERIODIC MAINTENANCE
2.7.

ENGINE OIL

2.7.1.
ENGINE OIL
Change engine oil at regular intervals, see 2.1.2 (PERIODIC
MAINTENANCE CHART).
IMPORTANT Use the recommended oil only, see 1.8.1 (TA-
BLE OF LUBRICANTS).
Do not overfill (top up beyond the "Max" level).
CHECKING ENGINE OIL
Place the motorcycle on firm and level ground.
Place the motorcycle on the centre stand.
WARNING
Allow the engine and exhaust system to cool
down before proceeding.
Stop the engine and allow it to cool, before draining the
oil in the crankcase, so that the oil itself is also cool.
IMPORTANT Proceeding without the preceding precautions
risks mistaking the engine oil level.
Unscrew and remove the cap/dipstick (1).
Clean off any oil with a clean cloth.
Completely insert the cap/dispstick (1) into the filler
hole, but do not screw it.
Now remove the cap/dipstick (1) and read the oil level
off the dipstick.
Max = maximum level
Min = minimum level.
The difference between the "MIN" and "MAX" levels is
about: 400 cc (24.4 cu in).
The correct level is just below the "Max" mark.
WARNING
Do not overfill (beyond the "Max" mark) or let
level drop below the "Min" mark, as this will
cause severe engine damage.
Top up as necessary.
TOPPING UP ENGINE OIL
Pour a small quantity of oil into the filler hole and wait a
minute to allow the oil to flow into the crankcase.
Check the oil level, and top up again as necessary.
Top up with small amounts of oil until the prescribed
level is reached.
Tighten the cap/dipstick (1) securely at the end of the
operation.
IMPORTANT Do not use the vehicle if insufficiently lubri-
cated or if the oil is dirty or of the wrong type, as this will in-
crease the wear of moving parts and can result in serious
damage.
2 - 18
WWW.PlanDeGraissage.ORG
LEONARDO 250 - 300

Advertisement

Table of Contents
loading

This manual is also suitable for:

Leonardo 300

Table of Contents