Table of Contents
Advertisement
3.2. Default Switch and Jumper Settings
Caution:
Figure 4.
Note:
Table 3.
Switch
1
2
3
4
®
®
Intel
Arria
16
Arrow.com.
Downloaded from
This topic shows you how to restore the default factory settings and explains their
functions.
Do not install or remove jumpers (shunts) while the development board is powered
on.
Default Switch and Jumper Settings
The Switch position is represented by the black box.
To restore the switches to their factory default settings, perform these steps:
1. Set the DIP switch bank (SW1) to match "SW1 DIP Switch Settings" table and the
"Default Switch and Jumper Settings" figure.
Note: In the following table, ON indicates the switch is to the upper position
according to the board orientation as shown in the "Default Switch and
Jumper Settings" figure.
SW1 Factory Default Settings
Bit Name
2
I
C flag
DC_POWER_CTRL
factory_load
security_mode
10 SoC Development Kit User Guide
Bit Function
Switch 1.1 has the following options:
•
ON (0) = System MAX V is the I
2
•
OFF (1) = HPS is the I
C master
Switch 1.2 has the following options:
•
ON (0) = Power off PCIE slot when it is present
•
OFF (1) = Power up PCIE directly
Switch 1.3 has the following options:
•
ON (0) = Load user design from flash at power up
•
OFF (1) = Load factory design from flash at power up
Resvered
3. Development Board Setup
683227 | 2023.07.12
Default Position
2
C master
Send Feedback
OFF
OFF
OFF
OFF
Advertisement
Table of Contents
