Fryer Installation - Frymaster HPRE80 Installation, Operation And Maintenance Manual

HIGH PRODUCTION RE (HPRE) E
2.1.2 Electrical Grounding Requirements
All electrically operated appliances must be grounded in accordance with all applicable national and
local codes, and, where applicable, CE codes. All units (cord connected or permanently connected)
should be connected to a grounded power supply system. A wiring diagram is located on the inside
of the fryer door. Refer to the rating plate on the inside of the fryer door for proper voltages.
The equipotential grounding lug indicated by illustration (right) allows all the
equipment in the same location to be electrically connected to ensure there is no
electrical potential difference between the units, which could be hazardous.
2.1.3 Australian Requirements
To be installed in accordance with AS 5601 and AS/NZS 3000:2007 local authorities, gas,
electricity, and any other relevant statutory regulations.
If casters are fitted, the installation must comply with AS5601 and AS1869 requirements.

2.2 Fryer Installation

Frymaster fryers equipped with legs are for permanent installations. Fryers fitted with legs
must be lifted during movement to avoid damage and possible bodily injury. For a moveable
or portable installation, Frymaster optional equipment casters must be used. Questions?
Call 1-800-551-8633
HPRE fryers in batteries greater than four frypots fryer ship in sections. The fryers are uncrated, removed
from pallets and assembled together. Important aspects during assembly include aligning and connecting the
drain system, oil return system, rinse-line system (where applicable), oil-return switch wiring harness and fryer
cabinets. Slight modifications to connecting hardware may be required when assembling the system. The
instructions below provide step-by-step instructions to assist the installer in assembly.
2
CHAPTER 2: INSTALLATION INSTRUCTIONS
Installing the Fryer
1
3
4 SERIES ELECTRIC FRYERS
WARNING
1
5
2-4
2
4
5
3