Operator Troubleshooting; Introduction - Frymaster HPRE80 Installation, Operation And Maintenance Manual

HIGH PRODUCTION RE (HPRE) E
CHAPTER 5: OPERATOR TROUBLESHOOTING
5.1

Introduction

This section provides an easy reference guide to some of the common problems that may occur
during the operation of this equipment. The troubleshooting guides that follow are intended to help
correct, or at least accurately diagnose, problems with this equipment. Although the chapter covers
the most common problems reported, you may encounter problems that are not covered. In such
instances, the Frymaster Technical Services staff will make every effort to help you identify and
resolve the problem.
When troubleshooting a problem, always use a process of elimination starting with the simplest
solution and working through to the most complex. Never overlook the obvious – anyone can forget
to plug in a cord or fail to close a valve completely. Most importantly, always try to establish a clear
idea of why a problem has occurred. Part of any corrective action involves taking steps to ensure
that it doesn't happen again. If a controller malfunctions because of a poor connection, check all
other connections, too. If a fuse continues to blow, find out why. Always keep in mind that failure
of a small component may often be indicative of potential failure or incorrect functioning of a more
important component or system.
Before calling a service agent or the Frymaster HOTLINE (1-800-551-8633):
 Verify that electrical cords are plugged in and that circuit breakers are on.
 Verify that frypot drain valves are fully closed.
Hot oil will cause severe burns. Never attempt to move this appliance when filled
with hot oil or to transfer hot oil from one container to another.
This equipment should be unplugged when servicing, except when electrical circuit
tests are required. Use extreme care when performing such tests.
This appliance may have more than one electrical power supply connection point.
Inspection, testing, and repair of electrical components should be performed by an
Disconnect all power cords before servicing.
authorized service agent only.
4
SERIES ELECTRIC FRYERS
DANGER
DANGER
5-1