General - Frymaster HPRE80 Installation, Operation And Maintenance Manual

HIGH PRODUCTION RE (HPRE) E

2.1 General

Proper installation is essential for the safe, efficient, trouble-free operation of this appliance.
Qualified, licensed, and/or authorized installation or service personnel, as defined in Section
1.7 of this manual, should perform all installation and service on Frymaster equipment.
Failure to use qualified, licensed, and/or authorized installation or service personnel (as
defined in Section 1.7 of this manual) to install or otherwise service this equipment will void
the Frymaster warranty and may result in damage to the equipment or injury to personnel.
Where conflicts exist between instructions and information in this manual and local or
national codes or regulations, installation and operation shall comply with the codes or
regulations in force in the country in which the equipment is installed.
Service may be obtained by contacting your local Factory Authorized Servicer.
All fryers shipped without factory supplied cords and plug assemblies must be hardwired
using flexible conduit to the terminal block located on the rear of the fryer. These fryers
should be wired to NEC specifications. Hardwired units must include installation of restraint
devices.
Adequate means must be provided to limit the movement of this appliance without
depending on or transmitting stress to the electrical conduit. A restraint kit (part number
826-0900) is provided with the fryer.
Frymaster Factory Authorized Servicer (FAS).
If this equipment is wired directly into the electrical power supply, a means for
disconnection from the supply having a contact separation of at least 3-mm in all poles must
be incorporated in the fixed wiring.
This equipment must be positioned so that the plug is accessible unless other means for
disconnection from the power supply (e.g., a circuit breaker) is provided.
The electrical power supply for this appliance MUST be the same as indicated on the rating
and serial number plate located on the inside of the fryer door.
If this appliance is permanently connected to fixed wiring, it MUST be connected by means
of copper wires having a temperature rating of not less than 167°F (75°C).
CHAPTER 2: INSTALLATION INSTRUCTIONS
If the restraint kit is missing contact your local
4 SERIES ELECTRIC FRYERS
NOTICE
DANGER
NOTICE
NOTICE
DANGER
NOTICE
2-2