Electrical Connections - Frymaster HPRE80 Installation, Operation And Maintenance Manual

HIGH PRODUCTION RE (HPRE) E

2.3 Electrical Connections

The fryer when installed must be electrically grounded in accordance with local codes, or in the
absence of local codes, with the National Electrical Code, ANSI/NFPA 70-(latest edition).
This fryer is equipped with three-prong (grounding) plugs for protection against electrical shock and
must be plugged directly into a properly grounded, three-prong receptacle. DO NOT CUT, REMOVE,
OR OTHERWISE BYPASS THE GROUNDING PRONGS ON THESE PLUGS!
TO LEVEL FRYERS EQUIPPED WITH LEGS, THE BOTTOM OF THE LEGS CAN BE
SCREWED OUT UP TO 1-INCH FOR LEVELING. LEGS SHOULD BE ADJUSTED SO
THAT THE FRYER IS AT THE PROPER HEIGHT IN THE FRYING STATION. FOR
FRYERS EQUIPPED WITH CASTERS, THERE ARE NO BUILT-IN LEVELING
DEVICES. THE FLOOR WHERE THE FRYER IS INSTALLED MUST BE LEVEL.
NOTE: If you need to relocate a fryer installed with legs, remove all the weight from each leg
before moving. If a leg becomes damaged, contact your service agent for immediate repair or
replacement.
Hot shortening can cause severe burns. Avoid contact. Under all circumstances, oil
must be removed from the fryer before attempting to move it to avoid oil spills and
the falls and severe burns that could occur. This fryer may tip and cause personal
injury if not secured in a stationary position.
1. When the fryer is leveled in its final position, install the restraints to limit its movement so that it
does not depend on or transmit stress to the electrical conduit or connection as well as to prevent
tipping. Install the restraints in accordance with the provided instructions (see illustration below).
If the restraints are disconnected for service or other reasons, they MUST be reconnected before
the fryer is used.
Adequate means must be provided to limit the movement of this appliance without
depending on or transmitting stress to the electrical conduit. A restraint kit (part
number 826-0900) is provided with the fryer. If the restraint kit is missing contact
your local Frymaster Factory Authorized Servicer (FAS).
CHAPTER 2: INSTALLATION INSTRUCTIONS
WARNING
4 SERIES ELECTRIC FRYERS
DANGER
DANGER
2-6