Advertisement
Available languages
Available languages
ENGLISH
Note: - since hair does not grow in one direction, you can
try different cutting directions (i.e. up, down, or across).
• To trim the mustache or beard and cut undesirable hair,
remove the installed attachment (7) from the blade block
(1) (pic. 11).
• Turn the blades of the clipper towards the hair and trim
mustache or beard carefully. Do not press the hair clipper
strongly, there is danger of getting injuries or cuts when
open blades come in contact with skin.
• When cutting hair, mustache or beard, the cut hair gets
under the attachment comb (7), switch the clipper off,
remove the comb attachment (7), remove the trimmed
hair, install the attachment comb back to its place and
continue cutting (pic. 12).
• During breaks or after you finish cutting hair, always
switch the clipper off by setting the power switch (2) to
the position "off".
CLEANING AND MAINTENANCE
• Switch the clipper off after using it.
• Remove the installed attachment comb (7).
• Clean the attachment comb (7) off hair with the brush (10).
• Remove the blade block (1) (pic. 2), clean the blade
block off hair with the brush (10).
• Use the brush (10) to clean the inner cavity under the
blades block (1) off hair (pic. 13).
• You can wash the blade block (1) under a weak water jet
(pic. 14). After drying the blade block (1) install it back
to its place (pic. 3).
• Clean the hair clipper body (3) with a soft, slightly damp
cloth, and then wipe it dry.
• Do not immerse the clipper, the power adapter (9) and
the battery charging cord (8) into water or other liquids.
• Do not use any solvents or abrasives for cleaning the
unit.
• Lubricate the blade block (1) after every use with the
lubricating oil (11).
REMOVING THE BATTERY
Do not throw the clipper away with usual household waste
after its service life expiration, disassemble the clipper, re-
move the battery and hand it over to a specialized center for
further disposal.
22
Advertisement
