Advertisement
Available languages
Available languages
• When the battery is fully charged, the indicator (4) will
glow green, disconnect the power adapter (9) from the
mains socket.
• Full charging of the rechargeable battery takes about
2 hours.
• A fully charged battery provides approximately 120 min-
utes of continuous operation.
WARNING:
– Do not charge the battery at temperature below +5 °C
and above +35 °C.
– If you haven't used the unit for a month or longer, charge
the battery completely before using the clipper.
– Never leave the unit connected to the mains unattended.
BLADE BLOCK
The blade block (1) is consumable and is not covered by
the warranty.
The consumer should check the condition of the cutting
edges of the blades by themselves, as the sharpening (pol-
ishing) of cutting edges is not covered by warranty.
LUBRICATING THE BLADE BLOCK
Before using the unit for the first time lubricate the blade
block (1) with oil (11) (supplied with the unit).
• Press the lock and remove the blade block (1) pulling
upwards (pic. 2).
• Apply the lubricating oil (11) to the junctions between the
fixed and moving parts of the blades.
• Install the blade block (1) in place, align the guides on
the blade block (1) with the openings and insert the blade
block (1) until the lock clicking, make sure that the blade
block (1) is fixed properly (pic. 3).
• Switch the hair clipper on by setting the power switch (2)
to the "on" position (pic. 4) and let it operate for approxi-
mately 30 seconds to spread the lubricating oil across
the rubbing surfaces. Switch the clipper off by setting
the power switch (2) to the "off" position and remove the
excessive oil with a dry cloth or paper towel.
Notes:
– Lubricate the blade block (1) after every use of the
hair clipper.
– For lubricating the blades use only the oil (11), supplied
with the unit, or the oil intended for similar devices.
ENGLISH
19
Advertisement
