Vitek VT-1354 Manual Instruction page 20

ENGLISH
– Do not use vegetable oil or oil that includes solvents.
Solvents will evaporate, and the remaining thick oil may
slow down the blades motion.
HAIR STYLING INSTRUCTIONS
• Hair should be clean and dry during hair cutting.
• Before starting to cut hair, switch the hair clipper on by
setting the power switch (2) to the position «on» (pic. 4)
and make sure that the hair clipper operates normally
and the blade block moves (1) smoothly. If there is
excess lubricating oil on the blades, switch the hair
clipper off by setting the power switch (2) to the posi-
tion "off" and remove the excessive oil with a dry cloth
or a paper towel.
• Seat a person so that his/her head is approximately at
your eye level, cover the person's shoulders with a towel
and set hair with the comb.
Reminder
– Cut off a small amount of hair at a time – if necessary
you can always return to the cut area of hair again for
additional cutting.
– The best haircutting results are reached on dry hair,
not wet.
– Comb the hair to reveal uneven locks.
– It is better to leave longer hair after cutting for the first time.
– After learning your clipper better, you will be able to
arrange your hair in any style you need.
Attachment combs
The cut-off hair length depends on the attachment comb
(7): «1 mm – 2 mm – 5 mm – 7 mm».
Install the selected attachment comb (7) on the blade block
(1) teeth upwards (pic. 5). Make sure that the attachment
(7) is locked on its installation place.
Step 1 (pic. 6, 7)
Set the attachment comb (7) "5 mm" or "7 mm".
Switch the clipper on. Hold the hair clipper with the blades
pointed upwards. Start cutting from the hair growth edge.
Slowly move the hair clipper upwards. This way cut all hair
at the bottom of the back of the head and near the ears.
Continue cutting hair hear top of the head.
20