Table of Contents
Advertisement
Programming partition parameters
LOCATIONS 88-109 ARE FOR PROGRAMMING DIFFERENT ACCOUNT CODES AND/OR
FEATURES FOR EACH PARTITION. IF A LOCATION IS LEFT UNPROGRAMMED, THE FEATURE
FOR PARTITION 1 AND THE ACCOUNT CODE FOR THE PHONE NUMBER WILL BE USED
LOCATION 88 - ACCOUNT CODE FOR PARTITION 1 (6 segments, numerical data)
Location 88 contains the account code that is sent when partition 1 is reported. If location 88
is left unprogrammed (all "10"s), then the account code corresponding to the phone number
that is dialled will be used. If the account code is less than six digits, program a "10" in the
segment immediately after the last digit of the account code. If the account code is 6 digits
long, program all 6 segments.
LOCATION 89 - ACCOUNT CODE FOR PARTITION 2 (6 segments, numerical data)
Location 89 contains the account code that is sent when partition 2 is reported. If location 89
is left unprogrammed (all "10"s), then the account code corresponding to the phone number
that is dialled will be used. If the account code is less than six digits, program a "10" in the
segment immediately after the last digit of the account code. If the account code is 6 digits
long, program all 6 segments.
LOCATION 90 - PARTITION 2 FEATURE AND REPORTING SELECTIONS (5 segments, feature selection data)
Location 90 is used to enable certain features that the user can access or see from the keypad
of the system. In addition, certain communicator reports are enabled in this location. Each of
these features can be enabled by partition. This location contains 5 segments, with eight
possible features per segment. Refer to location 23 for the feature selections. If all the
segments are blank (nothing enabled), the features for partition 1 will be used.
LOCATION 91 - PARTITION 2 ENTRY EXIT TIMERS (6 segments, numerical data)
Location 91 is used to enter the entry and exit times, in seconds. There are 2 separate entry
and exit times. Valid entries are 10-255 seconds. If all the segments are "0", the entry and exit
times for partition 1 will be used.
Segment 1
Segment 2
Segment 3
Segment 4
Segment 5
Segment 6
NX-8-EUR Installation manual
Entry time 1
Entry time that will be used when a delay 1 zone type
initiates an entry delay
Exit time 1
Exit time that will be used for all zones designated as
delay 1
Entry time 2
Entry time that will be used when a delay 2 zone type
initiates an entry delay
Exit time 2
Exit time that will be used for all zones designated as
delay 2
Reserved
Reserved
Page 70
02/07/06
Advertisement
Table of Contents
