Adding Or Replacing Memory - Gateway E-3400 System Manual

Adding or replacing memory

The Synchronous Dynamic Random Access Memory (SDRAM) Dual Inline
Memory Modules (DIMMs) supported by your system board conform to the
following standards:
Non-ECC (64-bit) memory
Unbuffered
PC133
Single- or double-sided configurations
512 MB maximum system memory
The system board contains two DIMM sockets. You can fill the sockets with
32-MB, 64-MB, 128-MB, or 256-MB DIMMs in any combination to expand
the memory capacity up to 512 MB.
No jumper settings are required for the memory size or type because the BIOS
automatically detects this information.
To add or remove DIMMs:
1
Turn off the system and disconnect the power cord, modem cord (if
installed), and all external peripheral devices.
2
Open the case (see "Opening the case" on page 15), observing the "Static
electricity precautions" on page 13.
Adding or replacing memory
29