Gateway E-3400 System Manual page 33

4
Lift the ring slightly, then pull it towards the center of the drive until
the spring latch releases. Lift the drive out of the chassis.
5
Remove the mounting plate from the old drive by lifting and sliding one
tab at a time until they unlock. Lift the mounting plate off the drive.
6
Position the new drive upside down in the mounting plate and snap it
into place.
7
Place the drive back into the drive bay.
8
Connect the power and data cables to the back of the drive. (See drive
documentation for proper drive jumper settings and cable orientation.)
9
Close the case (see "Closing the case" on page 17).
10
Reconnect the power and all other cords removed, then turn on the
system.
Adding a hard drive
The system comes with a metal drive-mounting bracket you can use to install
an additional internal hard drive. Due to difficulties in routing the existing
IDE connector cable to this drive, you will need to purchase a PCI IDE drive
controller add-in card and an additional IDE connector cable to complete the
installation.
26
Replacing and Adding System Components
Tabs