Olympus OM-1 Repair Manual page 76

D-10
3) Remove PUK2 x 3SO and 3PUK1.7 x 4SO on CA8742 (Case).
Then will come off:
CA8742 (Case)
CA8743 (Plate)
CA9060 (Collar)
4) Remove CA8801 (Nut)
5) Remove three PUK1.7 x 2.5SO on XCA8775 (Base plate).
Then will come off in a unit:
CA8754 (Shaft)
CA8775 (Base plate)
CA8774 (Spring)
CA8796 (Stopper)
CA8797 (Washer)
CA8781 (Shaft)
CA8803 (Stopper)
CA8799 (Stopper) and CA8800 (Stopper)
CA8798 (Shaft)
CA8723 (Bush)
CA8783 (Spring)
CA8778 (Lever)
CA8784 (Gear)
HK1.4 - 604BO
Disassembly of the part removed in a unit:
Remove CA8752 (Fastener) and then CA8749 (Lever).
CA8775 (Base plate) can be separated from CA8754
(Shaft) and further CA8774 (Spring) and CA8723 (Bush)
can be removed.
6) Remove two PUK1.7 x 1.8SO on CA9146 (Shaft) and CA8808 (Screw).
Then comes off CA9146 (Shaft).
The steps 1) through 6) shown above may be followed without
separating CA8702 (Body front part) from the Die-cast body.
7) Remove 3PUK1.7 x 3SO on CA9041 Base plate.
Then comes off CA9041.
http://olvmi] entia.org/'