Turbocharger Assembly - Kohler KDI 2504TM Workshop Manual

9

9.13 Turbocharger Assembly

Important
•
Before proceeding, perform the operation
described in
•
Ensure that tube B is not clogged.
1. Fasten the connecting sleeve A to the pipe B
with the clamp C onto the flange fitting D.
Important
•
Always replace the gasket F after each
assembly.
2. Lubricate and insert the gasket F into the
seat of the pipe G.
Important
•
Remove the plastic or foam caps from the
turbo compressor before assembling.
•
Replace nuts M with each assembly.
3. Check that the contact surfaces E are free
from impurities deformations or cracks,
otherwise replace exhaust manifold L.
4. Position the turbo-compressor H on the bolts
on the manifold L.
5. Fasten the turbo-compressor H with the nuts
M (tightening torque of 25 Nm).
6. Insert the sleeve T on the turbo-compressor
H and secure it with the clamp U.
7. Fasten the pipe G with the screws N to the
turbo-compressor H.
Important
•
Always replace the gasket P after each
assembly.
•
Before assembly of the tube Q, perform the
operation described in
•
Ensure that tube Q is not clogged.
8. Insert the gaskets P between:
EN 136
ASSEMBLY INFORMATION
Par. 2.18.
Par. 2.18.2 - point
Fig 9.81
Fig 9.82
Fig 9.83
2.