Cutting A Hole And Mounting Installation Plate - Toshiba MMK-UP0051DHPL-E(TR) Service Manual

5
CUTTING A HOLE AND MOUNTING INSTALLATION
PLATE
Cutting a hole
In case of installing the refrigerant pipes from the
rear:
To the center of the pipe hole
1. After determining the pipe hole position on
the mounting plate (➡), drill the pipe hole
(Ø65 mm) at a slight downward slant to the
outdoor side.
NOTE
• When drilling a wall that contains a metal
lath, wire lath or metal plate, be sure to use a
pipe hole brim ring sold separately.
Mounting the installation plate
Indoor unit outline
Hook
300
200
55
Hook
Pipe hole
Thread
Weight
Drain hose
position
Pipe hole
Ø65 mm
120 mm
Recommended mounting
screw positions
(Unit : mm)
350
200
55
Hook
Pipe hole
Drain hose
position
- 106 -
Space allows under the indoor
unit
• Space allows for moving range of the air inlet
grille and horizontal louver in operation above
curtain rails, window cornice or other objects.
460
Air inlet grille
Distance between bottom
of indoor unit to maximum
horizontal louver opening
Horizontal louver
CAUTION
• If have curtain rails, window cornice or other
objects, allow space from the indoor unit
should be 45 mm or more.
• If allow space is less than 45 mm, this can
affect the opening and closing of the air inlet
grille and the horizontal louver.
• However, there should be no objects in the
air outlet position.
It will block the air flow direction and drop
performance.
(Unit : mm)
Curtain rails,
window cornice
130
or other objects