Figure 59 Network Setting > Broadband > Cellular Lock (5G)
The following table describes the fields in this screen.
Table 25 Network Setting > Broadband > Cellular Lock (5G)
LABEL
NR(5G) Lock Management
PCI_Enable
Band
PCI
RFCN
SCS
Chapter 7 Broadband
DESCRIPTION
Slide this to the right to enable PCI (Physical Cell Identifier) Lock on a base station when
the Zyxel Device has a NR (5G) connection.
Enter the band number to which you choose to connect.
Note: Make sure to select the same band in the Network Setting > Broadband
> Cellular Band screen so as the Zyxel Device can connect to that
band.
Use this to enter the PCI number of the base station you want the Zyxel Device to
connect to (0 – 504).
Enter the RFCN (Radio Frequency Channel Number) for the NR (5G) frequency of the
specified PCI (1 – 65535).
Select the Subcarrier Spacing (SCS) from the drop-down list. Subcarriers are small signal
carriers that divide a frequency channel, which is the main carrier wave. Subcarrier
spacing is the space between each subcarrier. At the time of writing, SCS ranges from
15-120 KHz.You should select the same SCS that is used by the ISP.
NR/FWA Outdoor Series User's Guide
90