ZyXEL Communications NR/FWA Outdoor Series User Manual page 143

This tutorial uses the following example IP settings:
Table 45 IP Settings in this Tutorial
DEVICE / COMPUTER
The Zyxel Device's WAN
The Zyxel Device's LAN
IP Type
Use Interface
A
R's N1
R's N2
B
To configure a static route to route traffic from N1 to N2:
Log into the Zyxel Device's Web Configurator.
1
Click Network Setting > Routing.
2
Click Add new Static Route in the Static Route screen.
3
Configure the Static Route Setup screen using the following settings:
4
• Click the Active button to enable this static route. When the switch goes to the right, the function is
enabled. Enter the Route Name as R.
• Set IP Type to IPv4.
• Enter the Destination IP Address 192.168.10.1 and IP Subnet Mask 255.255.255.0 for the destination, N2.
• Click the Use Gateway IP Address button to enable this function. When the switch goes to the right,
the function is enabled. Enter 192.168.1.253 (R's N1 address) in the Gateway IP Address field.
• Select Default as the Use Interface.
• Click OK.
Now B should be able to receive traffic from A. You may need to additionally configure B's firewall
settings to allow specific traffic to pass through.
Chapter 10 Routing
IP ADDRESS
172.16.1.1
IPv4
Default
192.168.1.34
192.168.1.253
192.168.10.2
192.168.10.33
NR/FWA Outdoor Series User's Guide
143