Add New Rule - ZyXEL Communications NR/FWA Outdoor Series User Manual

The following table describes the labels in this screen.
Table 73 Security > MAC Filter
LABEL
MAC Address Filter
MAC Restrict Mode

Add New Rule

Set
Active
Host Name
MAC Address
Delete
Cancel
Apply
16.2.1 Add New Rule
You can choose to enable or disable the filters per entry; make sure that the check box under Active is
selected if you want to use a filter, as shown in the example below. Select Security > MAC Filter > Add
New Rule. The screen appears as shown.
Figure 131 Security > MAC Filter > Add New Rule
The following table describes the labels in this screen.
Table 74 Security > MAC Filter > Add New Rule
LABEL
Set
Active
Host Name
MAC Address
Delete
Chapter 16 MAC Filter
DESCRIPTION
Select Enable to activate the MAC filter function.
Select Allow to only permit the listed MAC addresses access to the Zyxel Device. Select
Deny to permit anyone access to the Zyxel Device except the listed MAC addresses.
Click the Add button to create a new entry.
This is the index number of the MAC address.
Select Active to enable the MAC filter rule. The rule will not be applied if Allow is not
selected under MAC Restrict Mode.
Enter the host name of a wired LAN client that you want to allow access to the Zyxel Device.
You can use up to 17 printable characters except [ " ], [ ` ], [ ' ], [ < ], [ > ], [ ^ ], [ $ ], [ | ], [ &
], or [ ; ]. Spaces are allowed.
Enter the MAC address of a wired LAN client that you want to allow access to the Zyxel
Device. Enter the MAC addresses in a valid MAC address format, that is, six hexadecimal
character pairs, for example, 12:34:56:78:9a:bc.
Click the Delete icon to delete an existing rule.
Click Cancel to restore your previously saved settings.
Click Apply to save your changes.
DESCRIPTION
This is the index number of the MAC address.
Select Active to enable the MAC filter rule. The rule will not be applied if Allow is not
selected under MAC Restrict Mode.
Enter the host name of a wired LAN client that you want to allow access to the Zyxel
Device. You can use up to 17 printable characters except [ " ], [ ` ], [ ' ], [ < ], [ > ], [ ^
], [ $ ], [ | ], [ & ], or [ ; ]. Spaces are allowed.
Enter the MAC addresses of a wired LAN client that you want to allow access to the
Zyxel Device in these address fields. Enter the MAC addresses in a valid MAC
address format, that is, six hexadecimal character pairs, for example,
12:34:56:78:9a:bc.
Click the Delete icon to delete an existing rule.
NR/FWA Outdoor Series User's Guide
187