ZyXEL Communications NR/FWA Outdoor Series User Manual page 64

Note: The fields in the screen may slightly differ based on the Access Technology your Zyxel
Device supports.
Note: The value is '0' (zero) or 'N/A' if the Access Technology the Zyxel Device is currently
connected to does not have this value in that specific parameter field or there is no
network connection.
The following table describes the labels in this screen.
Table 10 Cellular Info: Detailed Information
LABEL DESCRIPTION
Module Information
IMEI This shows the International Mobile Equipment Identity of the Zyxel Device.
Module SW This shows the software version of the cellular network module.
Version
SIM Status
SIM Card Status This displays the SIM card status:
None – the Zyxel Device does not detect that there is a SIM card inserted.
Waiting SIM Available – the SIM card is detected but not available yet.
Available – the SIM card could either have or do not have PIN code security.
Locked – the SIM card has PIN code security, but you did not enter the PIN code yet.
Blocked – you entered an incorrect PIN code too many times, so the SIM card has been locked;
call the ISP for a PUK (Pin Unlock Key) to unlock the SIM card.
Error – the Zyxel Device detected that the SIM card has errors.
IMSI This displays the International Mobile Subscriber Identity (IMSI) of the installed SIM card. An IMSI is
a unique ID used to identify a mobile subscriber in a mobile network.
ICCID Integrated Circuit Card Identifier (ICCID). This is the serial number of the SIM card.
PIN Protection A PIN (Personal Identification Number) code is a key to a SIM card. Without the PIN code, you
cannot use the SIM card.
Shows Enable if the service provider requires you to enter a PIN to use the SIM card.
Shows Disable if the service provider lets you use the SIM without inputting a PIN, or you disable
PIN Protection in Network Setting > Broadband > Cellular SIM.
PIN Remaining This is how many more times you can try to enter the PIN code before the ISP blocks your SIM
Attempts card.
IP Passthrough Status
IP Passthrough This displays if IP Passthrough is enabled on the Zyxel Device.
Enable
IP Passthrough allows a LAN computer on the local network of the Zyxel Device to have access
to web services using the public IP address. When IP Passthrough is configured, all traffic is
forwarded to the LAN computer and will not go through NAT.
IP Passthrough This displays the IP Passthrough mode.
Mode
This displays Dynamic and the Zyxel Device will allow traffic to be forwarded to the first LAN
computer requesting an IP address from the Zyxel Device.
This displays Fixed and the Zyxel Device will allow traffic to be forwarded to a specific LAN
computer on the local network of the Zyxel Device.
Cellular Status
Cellular Status This displays the status of the cellular Internet connection.
Chapter 6 Connection Status
NR/FWA Outdoor Series User's Guide
64