Table of Contents
Advertisement
M-97M(DP-M87)
M@ Multi-disc recordings
On to one tape, a single disc or from assorted discs up to a maximum of 32 tracks can be recorded.
Preparation: First, put the disc(s) to be recorded into the magazine and the Plus 1 Tray, leave the door closed.
1 Set up Deck B ready for recording.
d
® Insert the cassette tape.
Hepestoibe Fecniee
@ Set the tape
transport direction.
® Select the tape side(s) to
be recorded.
OIRECTION
= : Select two-side recording.
@ Select the Dolby NR
mode.
DOLBY NA
goes off.
2 Select the CD/LD input.
3 Set the CD player to PGM mode.
indicator lights up.
Remote controller
4 Select the track to be recorded.
@
Refer to page 32.
@ Select the disc.
@ select the track.
om
pIsc NO.
0
Remote control unit
@ Repeat steps @ and @ to program up to 32 tracks.
@ When
"FULL"
appears
on the display, this indicates that
tracks cannot be recorded any more.
(Select the total re-
cording time so that it does not exceed that of the tape.)
Notes:
1. The CCRS searches the peak level on a CD in a limited period of about 60 seconds.
Therefore, it could happen that the optimum level can-
not be adjusted, through it is a very rare case.
2. \f the length of a track on the CD is extremely long such as with a classical music, the CCRS cannot be used because the music cannot be
fit in one side of tape.
3. When the tune being recorded at the end of the tape is to be erased, the ending part of the previous tune may also be erased if the space
between the tunes is short.
5
Select the ERASE recording mode.
pense
[
FADE —»
|ERASE|—> ong,
The mode changes every time the key is pressed.
6
Press the
key.
Normal-speed recording.
Double-speed recording.
NOR
CCRS
HIGH
NOR
CCRS
HIGH
@ By the CCRS function, the recording starts after 90 seconds.
@
Records in the order of the selected tracks.
@
When proceeding through the multi-disc program, as the discs
are replaced the operations mentioned above are performed in
the same way.
When the discs are replaced, the CD pauses for 60 seconds.
Caan cal
a
First CD
ai ae ana
La jis]
Second CD ——
@
The operations as shown below occur at the end of tape where
it is reversed.
—_
Se
Second CD
——
'
Erasure of D
+—-
First CD
Stop after erasure of G
Recording of D from the begining
<=
Third CD
SecondCD
—
M-97/97M(En)
57
Advertisement
Table of Contents
